|
|
General Industrial & Engineering Products
|
Suppliers Directory
|
Master Metrology
Manufacturer And Exporter Of Fixtures.
| | Address : |
M-3/264, MHB Colony, Laxminagar, Parvati, Pune - 411 009, India |
| Telephone : |
+(91)-(20)-4444290 |
| Fax : |
+(91)-(20)-4440059 |
| Send : |
On-Line Trade Inquiry |
| |
|
Products |
|
Plain Plug Gauge - Master Metrology, based in Pune, is into manufacturing plug gauges made from special grade, hot isostatically pressed sub-micron grained tungsten carbide material, which is ground, and precision lapped for quality and longevity. These carbide plug gauges are available in sizes ranging from 0.5 to 200 mm diameter in three types of designs namely reversible, taper shank and segment and Trilock types. Plug gauges are manufactured to relevant IS, BS and DIN standards based on customer requests. Gauges of non-standard designs are also offered.
|
|
Tungsten Carbide Gauge - Master Metrology manufactures a range of tungsten carbide gauges. These include plain plug, pin, plain ring, snap, width, keyway, depth, flush pin, wear parts, wire guides, whirling chamber and nozzles, and screw plug and ring gauges. A special grade of hot iso-statically pressed, densomet, porosity free carbide is selected for above-mentioned products. Special lapping and grinding techniques developed by the company imparts high degree of surface finish and dimensional control on the gauges. These gauges have a lot of advantages over traditional steel gauges. Its high TRS, MM tungsten carbide outlasts steel by more than 30 times. Special features: high economical; special tungsten carbide gives 10-20 times more life as compared to steel gauges; highly wear resistant; less frequent calibration required; lower gauge procurement and planning costs; no danger of component rejection due to use of worn out gauges; and special preferential calibration services provided to our customers on priority.
|
|
Pin Gauge - Pin gauges from Master Metrology are manufactured in steel and tungsten carbide. Tungsten carbide pins are offered in diameters ranging from 0.8 mm to 16 mm. The steps of increments are 0.001 mm, 0.02 mm, 0.1 mm and 0.5 mm. A Collet type twin-head anodised handle can be supplied for flexible handling of pins. Tolerance limit of these pins is 2 +/- 1 microns. Pins of different lengths and sizes are supplied as per customer’s requirements.
|
| |
|
View More Supplier Pages
Page(s) : 1 •
2 •
3 •
4 •
5 •
| |
|
|
|
